The typical technical specifications of each series of PUMO servo electric cylinders are as follows. The specific values may vary slightly depending on the cylinder diameter, screw lead, and selected servo motor. The final selection will be subject to engineering confirmation. Rated thrust: The standard series offers gears such as 0.5kN, 1kN, 3kN, 5kN, 10kN, 20kN, 30kN, 50kN, and 100kN, with special customization up to 200kN or more; Effective travel: Conventional range is 50-1500mm, non-standard can be customized to 2500mm or more. For long travel, it is recommended to add intermediate support or use reinforced guidance to reduce screw deflection; Operating speed: continuously adjustable from 5-1000mm/s, the actual maximum speed is limited by the lead screw and the rated speed of the motor (large lead is suitable for high-speed light load, small lead is suitable for low-speed high thrust); Repetitive positioning accuracy: ± 0.02mm when using C7 grade ball screws, ± 0.01mm when using C3/C5 grade grinding ball screws, and ± 0.005mm when equipped with planetary roller screws or external grating rulers for full closed-loop. Transmission forms: precision ball screws (commonly used), planetary roller screws (heavy-duty high rigidity type), trapezoidal screws (economical micro); Common values for lead screw: 5mm, 10mm, 16mm, 20mm, 25mm, 32mm; Compatible brands of servo motors: Panasonic, Yaskawa, Delta, Huichuan, Siemens, Schneider, etc; Installation method: front flange, rear flange, ear shaft, rear hinge, side installation; Protection level: standard IP54/IP65, optional IP66 and retractable organ cover; Working environment temperature: -10~+60 ℃, special type -40~+80 ℃; Communication protocol: pulse+direction, ± 10V analog quantity Modbus RTU、CANopen、EtherCAT、PROFINET。

Optional accessories include: magnetic grating ruler/grating ruler fully closed loop, pressure sensor, anti rotation device, hard/soft limit switch, power-off holding brake, lubrication and grease injection port, etc. Understanding the interdependent relationship between the above parameters (thrust ∝ reduction ratio ∝ screw lead ⁻¹, speed ∝ lead × motor speed) is a prerequisite for making a reasonable selection. The PUMO technical department can provide free parameter verification and external dimension drawings based on customer working conditions.